Tablet Shade Installation Instructions
Installing the White Dog and a Fox Tablet Shade is easy.
The Shade comes with 5 pieces of adhesive backed Velcro that can be directly applied to the back of your tablet or to the back of a tablet cover. Each piece comes attached to its corresponding tab. Simply remove the adhesive backing and stick them to the back of you tablet.
Your shade can be installed directly to your tablet or to a tablet cover. The soft side of the Velcro will remain permanently installed on your tablet or cover even when the cover is not in place. For that reason some people chose to install the Velcro on a tablet cover that they can take off when the shade is not in use.
#1 Open up your tablet shade and stand it up. Remove the longest piece of Velcro from the top tab.
Installing the White Dog and a Fox Tablet Shade is easy.
The Shade comes with 5 pieces of adhesive backed Velcro that can be directly applied to the back of your tablet or to the back of a tablet cover. Each piece comes attached to its corresponding tab. Simply remove the adhesive backing and stick them to the back of you tablet.
Your shade can be installed directly to your tablet or to a tablet cover. The soft side of the Velcro will remain permanently installed on your tablet or cover even when the cover is not in place. For that reason some people chose to install the Velcro on a tablet cover that they can take off when the shade is not in use.
#1 Open up your tablet shade and stand it up. Remove the longest piece of Velcro from the top tab.
#2 Turn your tablet over. The long piece of Velcro will be installed across the top of the back of your tablet. Before removing the backing, take the Velcro and hold it in place centered across the top of your tablet to insure that it will not interfere with you camera eye, any plug in points or buttons. Most tablets are able to rotate the screen depending on the orientation of the tablet. So if your camera eye will be covered by the Velcro turn your tablet around 180 degrees. After locating where you will install the Velcro, remove the backing and stick the Velcro in place. Once installed firmly rub down to insure good adhesion.
#3 Attach the shade to the top piece of Velcro and see where the first side tabs contact the sides of your tablet. This will be where the next two pieces of Velcro will be installed.
(Important) the two pieces of Velcro that will now be installed on the sides of your tablet should be installed as far up the sides of the tablet as you can without covering any buttons or plug it points. After locating where you will install the Velcro, remove the backing and stick the Velcro in place. Once installed firmly rub down to insure good adhesion.
(Important) the two pieces of Velcro that will now be installed on the sides of your tablet should be installed as far up the sides of the tablet as you can without covering any buttons or plug it points. After locating where you will install the Velcro, remove the backing and stick the Velcro in place. Once installed firmly rub down to insure good adhesion.
|
#4 Attach the first side tabs to the tablet and pull the wings into place and locate the last two Velcro points. After locating where you will install the Velcro, remove the backing and stick the Velcro in place. Once installed firmly rub down to insure good adhesion.
|
